The Halden Meridian, our newest timepiece.

Hand-wound, finished by hand, and open to view through a sapphire caseback. Edition of 150.

The Calibre H1, our own movement.

Wound by hand. Runs for 72 hours. Finished by hand on every bridge.

Finished by hand, even where nobody looks.

About thirty hours by hand in every movement: Côtes de Genève, polished bevels, perlage.

Move over the bridges to look through the loupe

Made in Biel, with specialist help from the Jura.

Twenty-one jewels and the balance spring come from specialists there. Every other part is made at our benches in Biel.

Four gold screws keep it on time.

The balance is free-sprung, so there is no regulator lever. We set the rate by turning the screws by hand.

Wind it on Friday. It is still running on Monday.

Two mainsprings in two barrels. About thirty turns of the crown from empty.

167 parts, finished and assembled by hand.

Back together, one part at a time.

The Meridian

CHF 9,800150 pieces in the first year

  • CaseSteel, 38 mm, sapphire back
  • DialWhite grand-feu enamel
  • HandsHeat-blued steel
  • Strap
Reserve a MeridianDeposit CHF 1,000. Deliveries from spring 2027.
A white enamel dial on its firing tray at the mouth of the kiln, its rim glowing orange.

Our enamel dial,
fired at over 800 °C.

Powdered glass, fired again and again until the white is deep rather than flat. A dial can crack in the last firing. Then it starts again.

The workshop at seven in the morning: watchmakers at their benches under the north windows, one lamp lit at each bench.

Nine of us
work in one Biel workshop.

We make about four hundred watches a year.

Lene's hands lifting a wheel from an antique clock movement, its brass parts laid out in order on a cloth.
Lene HaldenRestored antique clocks for ten years before she made her own.
The first prototype movement in a parts tray: one barrel, plain unfinished bridges.
Visits by appointment at Rue des Horlogers 9, Biel/Bienne. atelier@halden.ch

Started by a clock restorer and an engineer.

Lene Halden and Tomás Rey began at two benches by a north window. They wanted to make watches by the hundred, slowly, and well enough for any good watchmaker to service for the next hundred years.

A hand drawing the H1's bridge layout in pencil on tracing paper, a compass and steel rule beside it.
Tomás ReyEngineered movements made by the hundred thousand. Drew the H1's first lines in 2019.

One of 150, numbered in the order you reserve.

A deposit of CHF 1,000 holds your Meridian. It is refunded in full on request at any time until your watch is ready.

142of 150 still open

  • Deposit, todayCHF 1,000
  • Balance, when your watch is readyCHF 8,800
  • Deliveries beginSpring 2027
Strap

Next, you leave this page for our secure reservation system. It takes the CHF 1,000 deposit and confirms your number.

Movement
Calibre H1, hand-wound, 72 hours from two barrels
Balance
Free-sprung, 3 Hz, four gold regulating screws
Finishing
About thirty hours by hand: bevels, Côtes de Genève, perlage, heat-blued screws
Case
Steel, 38 × 10.4 mm, sapphire front and back, water-resistant to 50 m
Dial
White grand-feu enamel, sunk small seconds
Edition
150 pieces in the first year, numbered on the caseback
A visitor holds the Meridian caseback up under the lamp while a second hand brings a loupe over the movement.

See the Meridian in person.

This winter we bring it to five cities. Wind one, look through the loupe and ask us anything. Choose a city and leave your email, and we will write with the time and address a few weeks before.

Choose a city
Choose a city.